English
Control handle on shaft
7
3
2
1
1
Throttle lever lock
2
Throttle trigger
3
Slide control
Slide control positions
4
STOP-0 – engine off – ignition is
switched off
5
Operating position F – Run – engine
is running or can start
6
START – Start – the ignition is
switched on – the engine can be
started
Symbol on slide control
7
h – Stop sign and arrow – to switch
off the engine, push the slide control
in the direction of the arrow at the
stop sign (h) to STOP-0
26
Starting
Press the throttle trigger lockout and
N
throttle trigger in succession
4
Hold both triggers down
N
Move the slide control to START
N
and hold it in position too
5
Release the throttle trigger, slide
N
6
control and throttle trigger lockout in
succession = starting throttle
position
Set the choke knob (8)
N
g If the engine is cold
e If the engine is warm – even if the
engine has already run but is still
cold
Press the manual fuel pump
N
bulb (9) at least 5 times - even when
bulb is filled with fuel
9
8
Starting
Lay the machine on the ground in a
N
secure position: It must rest on the
engine support and the deflector for
the cutting attachment
(if present): Remove the transport
N
guard on the cutting attachment
The cutting attachment must not touch
the ground or any other objects – risk of
accident!
Assume a firm stance – possibilities:
N
standing, bending or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the throttle trigger or
throttle trigger lockout while doing
so – your thumb should be under the
fan housing
NOTICE
Do not stand or kneel on the shaft!
FS 90, FS 90 R