Loading Goods; Lifting Loads; Unloading Goods; Restacking Goods - HanseLifter IMOW-E-BF Serie Mode D'emploi

Loading goods

Caution
Make sure that the goods are correctly
palletized and do not exceed the vehicle
permitted load capacity.

Place the stacker truck at a right angle
directly in front of the goods to be transported.

Push the forks as far in as possible
underneath the pallet.

The pallet/goods must steadily rest on the
fork.

Lifting loads


Now lift up the goods with the forks to
approx. 5 to 10 cm above the ground, and
make sure that the load is resting steadily on
the forks.

If you have larger goods that obstruct your
view, call a guide for help or drive backwards.

Unloading goods


When you reach the unloading point,
reduce speed.

Stop the stacker truck directly in front of the
unloading location.

Check the unloading location for its
condition, and make sure that the unloading
location is designed to carry the respective
load.

Correct the position of the stacker truck, if
necessary, until the desired unloading spot is
finally reached, and stop the stacker truck.

Make sure the stacker truck is positioned
properly.

Now slowly put down the goods. Make sure
that the goods stand securely.

Slowly reverse the stacker truck.

After you have freed the fork, return it to its
basic position (fork completely lowered).
IMOW-E-BF series Any kind of reproduction, even in parts, is not permitted.

Restacking goods

When approaching the area where the goods are
located, reduce the speed of the stacker truck.

Stop the stacker truck at a clearance of
about 30 cm (distance of fork to goods) directly
in front of the goods.
'

s Check the condition of the goods.

Make sure that the forks are positioned
properly.

Move the forks slowly forward as far as
possible into the pallet/frame, and stop the
stacker truck.
Note
If the forks cannot be fully inserted, use the
following procedure: Insert the forks up to ¾, lift
the pallet 5 to 10 cm, reverse a little (approx. 10
to 20 cm) and put the pallet down again.
Now move forward again to push in the forks
completely.

Lift up the goods by 5 to 10 cm.

Make sure that there are no people or
obstacles in the path to block your way, and
then carefully drive in reverse.

Raise/lower the forks as far as necessary.

Now drive to the unloading location.
Note
Avoid placing the load down hard on the ground
to protect the load and the ground.
Page 25 of 48