Loading And Stability; Align The Load Towards The Centre; Commissioning; Operation - HanseLifter DSHT-05 Mode D'emploi

Attention
The power supply lines must not be driven over or walked on. Under certain circumstances, this can cause
internal damage of the supply lines and become a significant source of danger for electrical accidents.

Loading and stability

Align the load towards the centre

There are differences between the individual goods to be lifted to such as: shape, centre of gravity, packaging
etc. It is important that attention is paid to these differences during loading, so that the goods are always loaded
with the centre of gravity towards the middle (see Figure 2 Load centre of gravity).
The visual centre of gravity is not always the actual centre of gravity. Pay attention to instructions on the
packaging relating to the centre of gravity.
Figure 2 Load centre of gravity

Commissioning

Operation

Figure 4 Operating buttons

DSHT-05 series any kind of reproduction, even in parts, is not permitted.
Figure 3 Load distribution
Lifting:
1
press and hold the button to carry out the lifting
operation. The lifting operation continues as
long as the "Lifting" button is pressed, or until
the limit stop is reached.
2 Lowering:
press and hold the "Lowering" button to carry
out the lowering operation. The lowering
operation continues as long as the "Lowering"
button is pressed, or until the limit stop is
reached.
Emergency stop button with key:
3
Press the emergency stop button to interrupt
the power supply. The button locks in a
recessed position. Turn the key in a clockwise
direction to reactivate the electrical circuit. The
button springs back out from its recessed
position into the normal position.
Also use the switch
unauthorised use. Press in the emergency stop
button and pull out the key.
UK
to secure against
Page 11 of 16