Hydraulic Oil; Warranty; Original Parts And Accessories; Tightening Torques - HanseLifter DSHT-05 Mode D'emploi

6 Tabletop lowers independently

Hydraulic oil

Standard quality oil should be used between +5 and +40 °C, and special low temperature oil at an ambient
temperature between -35 to +5 °C.
Name
Hydraulic oil

Warranty

Original parts and accessories

Only use original HanseLifter® parts for your HanseLifter lift table. The installation of spare parts and
accessories from other manufacturers is not tested and approved and can adversely affect the properties of the
equipment for this reason. Any liability of the manufacturer is excluded for damage caused by the installation of
non-original parts and accessories. In addition, the warranty is void if replacement parts or third-party
accessories are installed without authorisation.
Use only HanseLifter®

Tightening torques

Dimension
M 6
M 8
M 10
M 12
M 14
M 16
M 18
M 20
M 22
M 24
M 27
M 30
M 36 882 - 1078

Note:

•
Only use screws of strength class 8.8 for all load-bearing and other important parts.
The strength classes are listed in the table above
DSHT-05 series
- Oil pollution in the valve
- Seals defective
- Lowering valve defective
- Leak in pressure valve / pump

Table 2 Troubleshooting

Trade name, code
L-HM32
L-HV32

Table 3 Hydraulic oil

®
products.
4.6 5.6
4-5 5-7
10-12 12-15
20-25 25-31
35-44 44-54
54-69 69-88
88-108 108-137
118-147 147-186
167-206 206-265
225-284 284-343
294-370 370-441
441-519 539-686
529 - 666 666 - 833
1098 - 1372

Table 4 Tightening torques

any kind of reproduction, even in parts, is not permitted.
Recommendation
HanseLifter
Liftol HYSTAR 32
Liftol HYCOLD 32
in very cold environment
Tightening torque (Nm)
6.6
6-8
14-18
29-39
49-64
83-98
127-157
176-216
245-314
343-431
441-539
637-784
784 - 980
1323 - 1677
- Change oil
- Replace seals
- Replace valve
- Replace parts
Quantity
Ca4-5ll
8.8
9-12
22-29
44-58
76-107
121-162
189-252
260-347
369-492
502-669
638-850
933-1244
1267 - 1689
2214 - 2952
Page 15 of 16
UK