Damage; Possible Problems And Solutions - HanseLifter DSHT-05 Mode D'emploi

Warning
Never work on lines that are under pressure.

Damage

If any damage occurs during operation and makes it impossible to continue work safely, work must be stopped
and the defect must be corrected.
The correction of small defects, such as for example the replacement of fuses, can quickly be carried out on-site
if the appropriate spare part is available, but must only be performed by a trained service technician. Please
note that the equipment must be switched off to do so.
The equipment must be switched off and the emergency stop button must be pressed prior to any work on
electrical components. Then, disconnect the equipment from the power supply.
Warning
Never work on equipment which may be connected to a power supply. Make sure that the power supply of
the equipment is unplugged and secured against accidental switch-on, prior to any work taking place.

Possible problems and solutions

Note: Repair work must be performed only by trained service technicians that are qualified for this
work.
No
Problem
.
1 Hydraulic pump does not work
Tabletop no longer lifts up
2
(motor is running)
3 Motor not running
4 Tabletop can not be lowered
5 Oil - leakage
DSHT-05 series
Possible cause
- Defect fuse
- Loose cable connections
- Motor defective
- Switch for lifting is defective
- Power cable is not connected
- Emergency stop button pressed
- Safety edge triggered
- No / too little hydraulic oil in the
equipment
- Dirty oil in the equipment
- Load too heavy
- Lowering valve no longer closes
- Hydraulic pump does not work
- Reversed phase of mains voltage
- Voltage too low
- Loose cable connection
- defective cable / motor / contacts
- Lowering valve set incorrectly
- Seals hardened / perished
- Hydraulic oil level too high
any kind of reproduction, even in parts, is not permitted.
Instruction
Under no circumstances should work be carried
out on the hydraulic system as long as any
pressure remains in the hydraulic lines. Non-
compliance can cause serious accidents.
- Replace fuses
- Connect cables
- Replace motor
- Replace switch
- Connect power cable
- Release emergency stop
button
- Carry out a short lifting
operation to release security
lock
- Refill oil
- Change oil
- Check weight of the load
- Clean/replace
- Check pump
- Test phase scheme of the
socket
- Check mains voltage
- Tighten cables
- Replace defective parts
- Replace / adjust valve
- Replace seals
- Drain hydraulic oil
UK
Possible solution
Page 14 of 16