Intended Use; Misuse; Installation; Setup. Example - HanseLifter DSHT-05 Mode D'emploi

Intended use

Only use the lift table for the lifting of goods or loads. The lift table must only be used in dry rooms with level
floors. Keep the lift table away from moisture and wetness. If the lift table has come into contact with e.g. rain,
dry the lift table immediately and lubricate all moving parts at the grease nipples provided. Contact with dust,
sand and other abrasive and aggressive materials must also be avoided. Make sure that no belts or ropes get
caught in the moving parts.
Protect the lift table against aggressive or dirty substances.

Misuse

•
The transport of people or animals on the lift table is forbidden.
•
Do not reach into moving parts and ensure that no other person reaches into moving parts.
•
Make sure that nothing is located under the tabletop. There is danger of crushing.

Installation

Setup. example

It is necessary to fix the lift table to the floor for a fixed installation. To do this, use the existing holes in the floor
of the lift table. Make sure that the floor on which the lift table is installed and operated has sufficient load
capacity for the lift table and the maximum load. Also take into account the dynamic forces that can occur when
the load is raised and lowered.
maximum total load = net weight of the lift table + maximum lifting capacity
Only use fixings that are specially suited to the corresponding floor type.
If there are any doubts, consult a specialist or ask the architectural firm that designed the floor, which fasteners
are suitable and if the floor is suitable for the forces arising.

Power supply

The lift tables require a 400V / 16A power supply.
Make sure all the cables and lines are laid so they do not cause a tripping hazard or are inside the work area.
The warranty does not cover damage caused by external force or driving/walking over the lines.
DSHT-05 series

Figure 1 Fixing holes

any kind of reproduction, even in parts, is not permitted.
UK
Page 10 of 16