Safety Instructions Operating Materials; Hydraulic Oil; Personal Protective Equipment; General Description - HanseLifter DSHT-05 Mode D'emploi

Safety instructions operating materials

A range of operating materials are required for the operation of the lift table. These operating materials are:

1. Hydraulic oil

Instruction
All operating materials are subject to specific regulations and safety instructions. Follow the respective
safety instructions.
Hydraulic oil
•
Avoid skin and eye contact
•
In case of direct contact of oil with the eyes or mucous membranes, rinse with plenty of clean water and
consult a doctor immediately.
•
Do not inhale oil mist
•
Always transport oils in containers intended for this purpose. Never allow oils to enter ground water or
waste water.
•
Dispose of waste oils and oily waste according to regulations
•
Wear protective clothing such as gloves, goggles and apron when working with oils.

Personal protective equipment

Always wear the prescribed protective equipment when working with the lift table. Observe additional company
safety regulations, if required.

General description

The lift tables are intended for stationary operation for the lifting and lowering of loads and pallets. They are
characterised by ease of use, safety and reliability.
Lifting is performed by a hydraulic pump which is powered by an electric motor. Power is supplied via a 400V /
16A socket. Operation takes place via a control panel, which is connected to the controls of the lift table through
electric cables. Operation can only be carried out when the equipment is switched on.
DSHT-05 series any kind of reproduction, even in parts, is not permitted.
UK
Page 8 of 16