Legend; General Instructions - HanseLifter DSHT-05 Mode D'emploi

Legend

The following symbols are used in these operating instructions to draw attention to dangers, special
features and safety requirements.
Attention, warning, danger, safety instruction
This type of symbol indicates that there is a danger. The danger is shown with a corresponding symbol, which is
explained further in the accompanying text.
Instruction
This type of symbol draws attention to special features of the machine. Tips and instructions are also indicated,
which increase the performance or service life of the machine.
Protective clothing, protective measures
This type of symbol draws attention to special protective equipment required when working with the machine.

General instructions

The following must be observed at all times to ensure personal safety and the safety of the equipment:
•
Only trained and authorised persons are allowed to operate the lift table.
•
Before starting work, check all controls and moving parts for freedom of movement. If there is any damage
or there are any other causes for concern, the lift table must only be used again once it has been repaired
correctly.
•
Work on the lift table must be stopped immediately if errors or malfunctions occur, for example, if the lifting
table loses hydraulic oil. Secure the lifting table against unauthorised use and have it repaired by
appropriately trained service personnel.
•
When loading the lift table with goods, in particular large/bulky goods, ensure that the table is loaded evenly
and is not overloaded.
•
Always observe the centre of gravity of the load. Always make sure that the stability of the lift table is
guaranteed when working.
•
If there are additional accessories or other subsequently installed features on the equipment, also those of
other manufacturers, attention must be paid to the corresponding operating instructions of the respective
manufacturer.
•
All warranty claims and the declaration of conformity will become invalid if technical changes have been
made to the equipment.
•
Only operate the lift table using the manual operating unit. Do not touch moving parts. Avoid the danger
zone below the plate in the area of the scissors at all times when working with the equipment. Non-
observance can lead to serious injuries caused by the scissors and the lifted load.
•
Improper use of the lift table (other than described here) can lead to accidents or injuries. Always adhere to
the method of operation specified.
•
It is prohibited to allow persons to stand on the plate or to lift them.
•
Repairs must only be undertaken by qualified personnel.
•
Only qualified personnel must be used if the lift table is to be dismantled at the end of its service life.
•
Observe the temperature range of the equipment. In the worst case scenario, its use in locations that are
too hot or too cold can cause defects in the equipment, and can cause the operator to experience
hypothermia/frostbite or burns/irritation.
DSHT-05 series any kind of reproduction, even in parts, is not permitted.
UK
Page 5 of 16