General Safety Instructions; Guidelines And Instructions; Operator; Checks - HanseLifter DSHT-05 Mode D'emploi

can lead to damage to the equipment and endanger the operator and bystanders. The safety valve must
never be used for "weighing", or as an indicator of the maximum load. Always weigh the goods before
loading them on to the lift table.
•
Always engage the safety bracket when the tabletop has been raised, to secure the tabletop against
unintentional lowering.
•
Disconnect power from the equipment before cleaning and maintenance.
•
Never use water to clean electrical components of the lift table. Use compressed air or a slightly damp cloth
to clean surfaces. Never touch live parts. Disconnect the equipment from the power supply before cleaning.
•
The lift table poses a certain amount of electrical danger. Injury to the operator and damage to equipment
and goods may occur if the lift table is used improperly, manipulated or not repaired correctly, or if incorrect
replacement parts are used.
•
Make sure that the equipment is never exposed to any moisture. If exposed to moisture, disconnect the
power supply from the equipment and dry it accordingly. Only use the device when it is completely dry.
•
The electrical components (motor, controller, etc.) can become warm during operation. Take care not to
touch any warm or hot parts. Wait until the parts have cooled down before the lift table is serviced, checked,
cleaned, etc.
Immediately discontinue work if components reach excessively high temperatures during operation, disconnect
the power supply and have the lift table checked by a qualified service technician before renewed use.

General safety instructions

Residual risks can occur when dealing with equipment, despite observance and compliance with all rules and
regulations.

Guidelines and instructions

Please note the following instructions in order to use the lift table correctly and as intended:
•
The operator of the lift table must be properly instructed in its use by their superiors.
In addition, applicable national legislation and regulations must be observed.

Operator

The operator must be mentally as well as physically capable of using the lift table.

Checks

A periodic inspection of the lift table must be carried out once a year in accordance with the statutory provisions,
and the test results must be recorded in writing.
The lift table must be examined by a qualified person. A test log must be created and entered in the test book.

Technical modifications

Any alteration or manipulation to the lift table and attached equipment is prohibited.
Should you have any questions about additional accessories, please consult the dealer from which you
purchased the additional equipment, and consult the dealer from which you purchased your HanseLifter lift
table.
HanseLifter is of course also at your disposal.
HanseLifter®
GESUTRA GmbH
Straubinger Str. 20
28219 Bremen
+49 (0)421 33 63 62 00
www.hanselifter.de

Original parts and accessories

Use only original HanseLifter parts for your HanseLifter. The installation of spare parts and accessories from
other manufacturers is not tested and approved and can adversely affect the properties of the equipment for
this reason. Any liability of the manufacturer is excluded for damage caused by the installation of non-original
parts and accessories. In addition, the warranty is void if replacement parts or third-party accessories are
installed without authorisation.
DSHT-05 series any kind of reproduction, even in parts, is not permitted.
UK
Page 7 of 16