Working With The Blender - SilverCrest SKM 550 B2 Mode D'emploi

Proceed as follows to prepare the appliance for
operation using the continuous shredder 7:
1) Press down the release button e and move
the pivot arm t into operating position 4
(see the section "Operating positions").
2) Set the mixing bowl 6 into place. The base
of the mixing bowl 6 must click into the re-
cesses u on the appliance.
3) Press down the release button e and move
the pivot arm t into operating position 2.
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder 7 into the
hub socket (aligning the marking " " on the
continuous shredder 7 with the marking "
on the pivoting arm t).
Turn it in an anti-clockwise direction until the
continuous shredder 7 clicks firmly in place
(and the marking " " on the continuous shred-
der 7 is aligned with the marking "
the pivoting arm t).
6) Set the drive shaft 0 into place.
7) Depending on the task you want to perform,
place the cutting q, shredding 9 or grating
disc 8 onto the drive shaft 0 of the continous
shredder 7.
8) Place the lid with the pusher w onto the con-
tinuous shredder 7 (so that the marking "
on the lid w is lined up with the marking " "
on the continuous shredder 7) and lock the
lid in (marking "
up with the marking " " on the continuous
shredder 7).
9) Turn the rotary switch r to the required setting.
NOTE
► Do not press too much food into the continuous
shredder 7. Take note of the table in the sec-
tion "Recommended filling quantities".
10) Add the ingredients through the opening in the
lid with the help of the pusher.
SKM 550 B2
" on
" on the lid w is lined
After using your appliance
1) Switch the appliance off using the rotary
switch r.
2) Turn the continuous shredder 7 anti-clockwise
and remove it.
3) Disassemble the continuous shredder 7 and
clean all parts as shown in the section "Clean-
ing and care".

Working with the blender

WARNING! RISK OF INJURY!
► Allow hot fluids to cool to a lukewarm tem-
perature (approx. 30 - 40°C) before pouring
them into the blender 4.
"
WARNING! RISK OF INJURY FROM
SHARP KNIFE/ROTATING DRIVE!
► Never put your hand into the attached
blender 4 while it is running!
Remove the blade from the blender 4 only
►
when it is at a complete standstill.
Only use the blender 4 with the lid firmly in
►
position.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
"
Proceed as follows to prepare the appliance for
operation using the blender 4:
1) Press down the release button e and move
the pivot arm t into operating position 3
(see the section "Operating positions").
GB │ IE │ 27 ■