Troubleshooting; Technical Data - SilverCrest SKM 550 B2 Mode D'emploi

Troubleshooting

If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut-out.
–
Turn the rotary switch r to 0.
–
Remove the plug from the wall socket.
–
Allow the appliance to cool for 15 minutes.
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start.
–
Wait a further 15 minutes and try switching
on again.
If the appliance does not switch itself on:
–
Check that the plug is correctly connected
to a wall socket.
–
Check to make sure the protective cover
for the drive hub for the blender 4 and for
the continuous shredder 7 and the mixing
bowl 6 are all positioned correctly and
clicked into place.
–
Check to see if the pivoting arm t is in the
required position (see section "Operating
positions").
If the steps described above do not solve the problem,
then the appliance is defective. Arrange for it to be
repaired by a qualified specialist technician or by
the Customer Service Department.
■ 30 │ GB │ IE

Technical data

Nominal voltage 220–240 V ∼ (AC), 50 Hz
Nominal power 550 W
CO time:
3 minutes
blender 4
Max. capacity
Mixing bowl:
Blender:
Protection class II /
All of parts of this appliance
which come into contact
with food are food-safe.
CO time
The CO time (continuous operation time) is the
amount of time an appliance can be operated
without the motor overheating and becoming dam-
aged. After the appliance has been operated for
the given CO time, switch it off until the motor has
cooled down.
We recommend the following operating times
when working with the continuous shredder 7
and mixing bowl 6:
After using it for 10 minutes, allow the appliance to
cool down for 15 minutes.
Otherwise the appliance may overheat and
activate the safety cut-out (see section "Trouble-
shooting").
approx. 3.8 l
approx. 1 l
(double insulation)
SKM 550 B2