Working Speeds; Working With The Kneading Hook, Beater And Whisk - SilverCrest SKM 550 B2 Mode D'emploi

Working speeds

ATTENTION! PROPERTY DAMAGE!
► Operate the appliance with the respective
accessories only at the specified speed levels.
Otherwise the appliance could be damaged!
Accesso-
Position
SKM 550 B2
Speed
ries
setting
1, 2, 3, 4
1, 2, 3, 4
1, 2
3, 4
2, 3, 4
Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fingers in the mixing bowl 6
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit z is at a complete
standstill! After being switched off, the drive
unit z will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being used are fitted with their
protective covers.
Proceed as follows to prepare the appliance for
operation using the kneading hook 1, beater 3
and whisk 2:
1) Press down the release button e and move the
pivoting arm t into operating position 4 (see
the section "Operating positions") (Image A).
2) Set the mixing bowl 6 into place. Check that the
base of the mixing bowl 6 is inserted fully into
the recesses u provided for it on the blender.
3) If you want to use the kneading hook 1, insert
the dough deflector into the drive unit z
(Image D). Ensure that the hole through which
the kneading hook is inserted is lying over the
mounting hole on the drive unit z.
4) Depending on the task to be performed, insert
the kneading hook 1, beater 3 or whisk 2 so
that they firmly click firmly into the drive unit z.
5) Add the ingredients you wish to process into
the mixing bowl 6.
GB │ IE │ 25 ■