First Use; Operating Positions - SilverCrest SKM 550 B2 Mode D'emploi

First use

1) Take all the parts out of the box and remove
the packaging material and any protective
wrapping or stickers.
2) Clean all components as described in the section
"Cleaning and Care". Ensure that all parts are
completely dry.
3) Place the appliance on a clean and level
surface.
4) Secure the appliance to the surface using its
four suction discs.
5) Pull the power cord out of the cable storage
compartment i.
6) Insert the plug into the mains power socket.
NOTE
You can store the kneading hook 1, the
►
whisk 2, the beater 3 and the shredding
disc 8, the grating disc 9 and the rotary
cutter disc q in the accessories holder 5.
DANGER – ELECTRIC SHOCK!
If you want to attach the accessories holder 5
►
to the wall using the mounting materials pro-
vided, you should make sure before you start
drilling that there are no electric cables, wires
or pipes running behind the wall surface
where you want to drill!
7) Mark the drill holes on the wall using the ac-
cessories holder 5.
8) Use a 6 mm bit to drill holes at the pre-marked
positions on the wall.
9) Push a wall plug into each hole.
10) Screw the screws into the wall plugs so that they
stand proud of the wall just enough to allow you
to hang the accessories holder 5 on them.
11) Place the accessories holder 5 over the
screws and push it downwards so that the
accessories holder 5 fits firmly on the screws.
■ 24 │ GB │ IE

Operating positions

ATTENTION! DAMAGE TO PROPERTY!
► Only operate the appliance with the acces-
sories correctly inserted and in the operating
positions shown in this table. NEVER operate
the appliance without ingredients.
Position
1
2
3
4
5
Accessories
Positioning the mixing
bowl 6
Using the kneading
hook 1, beater 3
and whisk 2
Insertion of large
quantities of foodstuffs
for processing
SKM 550 B2