Working With The Food Processor; Working With The Mixer - SilverCrest SKM 550 A1 Mode D'emploi

Working with the food
processor
Note: Ensure that on the swivel arm
the kneading hooks
mixing beater w
Proceed as follows to prepare the appliance for
operation with the food processor
• Press the unlocking button
the swivel arm into operating position 4
h
(see chapter "Operating positions") (Fig
• Insert the mixing bowl
bowl must engage in the recesses
y
appliance.
• Press the unlocking button
the swivel arm into operating position 1
h
(see chapter "Operating positions").
• Remove the drive protection lid for the food
processor (Fig.
u
• Insert the food processor
(The "dot" marking on the food processor
the "arrow" marking on the swivel arm
then turn it clockwise as far as it will go (The "lock"
marking on the food processor
"arrow" marking on the swivel arm
• Insert the drive shaft
• Depending on the task to be performed, place
the cutting , rasping
s
onto the drive shaft
• Place the lid with stodger
cessor and latch it down.
u
• Set the rotary switch
Note: Do not press too many ingredients in the
food processor
u
chapter „Recommended filling quantities".
• Insert ingredients through the loading shaft with
the stodger d .
neither
h
, the whisk nor the
q e
are attached.
u :
down and bring
f
. The base of the mixing
y
on the
k
down and bring
f
).
u into the drive opening
h
onto the
u
).
h
a .
or rubbing disc
o i
a of the food processor
onto the food pro-
d
to the desired level.
g
. Take note of the table in the
Risk of injury from rotating parts!
To avoid personal injury and damage to the appli-
ance, NEVER insert or place your hands or foreign
objects into the loading shaft. Only insert ingre-
dients by use of the stodger.
Only change accessories when the drive motor
is at standstill! After being switched off, the drive
motor continues to run for a short time. The ap-
j
pliance may only be used when the drive openings
not being utilised are covered with drive protection
lids. In cases of malfunction switch the appliance
). off and remove the plug from the wall socket,
this will avoid an unintentional switching-on of the
appliance.
On task completion
• Switch the appliance off with the rotary switch
• Turn the food processor
remove it.
• Disassemble the food processor
parts (see chapter „Cleaning and care").
to
u
) and

Working with the mixer

Risk of scalds!
Allow hot fluids to cool to a hand-warm temperature
(ca. 30–40°C) before they are poured into the
mixer .
r
u .
Proceed as follows to prepare the appliance for opera-
tion with the mixer
• Press the unlocking button
swivel arm
chapter „Operating positions").
• Remove the drive protection lid for the mixer
(Fig.
• Fit the mixer
to the "point" on the base unit) and turn it anti-
clockwise as far as it will go (Fig.
- 46 -
u anti-clockwise and
:
r
f
h into operating position 3 (see
).
("Arrow" marking on the base
r
j
.
g
and clean all
u
and bring the
).