Display Symbols Of The Work Display (Display 41) - Leister UNIROOF AT Mode D'emploi

8.4. Display symbols of the work display (Display 41)

Symbol
345
°C
440
485
°C
440
During operation, the setpoints of the welding parameters (drive in m/min or ft/min, tem-
perature in degrees Celsius or Fahrenheit, air volume in percent and information notes are
displayed as required (see Application Mode: Displaying current values).
Use the Up/Down arrow keys (30) to switch between the welding parameters and adjust
the values individually with the Minus/Plus arrow keys (32).
Meaning
Symbol drive/welding speed [m/min or ft/min]
Symbol air temperature [°C or °F]
Symbol air volume [%]
Information notes on work display
Welding temperature too low, heat-up process.
Up arrow and progress bar show that the desired higher temperature has still
not yet been achieved. The fl ashing number above the progress bar designates the
currently achieved actual value (345); the value to the right of the bar (440) shows the
nominal value of the selected welding profi le or of the individual setting.
Welding temperature too high, cooling-down process.
Down arrow and progress bar show that the desired lower temperature has still not
yet been achieved. The fl ashing value above the bar designates the currently achieved
actual value (485); the value to the right of the bar (440) shows the nominal value of
the selected welding profi le or of the individual setting.
Symbol for Standby mode.
Symbol for Cool Down Mode
Symbol for hardware error message.
The device is no longer ready for operation. Contact an authorized Leister Service
Center.
(Note the respective error code in the Warning and Error Messages chapter).
Symbol for Hardware error message (heating element is defective).
The device is no longer ready for operation. Contact an authorized Leister Service
Center.
Symbol for Overtemperature warning message. Allow the device to cool down.
59