Leister UNIROOF AT Mode D'emploi page 71

Safety clamp
Art. No. 155.577
Caution! Secure the hot air welder with the carrying handle (5) only!
Caution! The welder is never permitted to be fastened to single hitching points which allow ropes
to sag! The connection equipment must always be set to as short a length as possible in order
to completely eliminate the chance of falling over the edge of the parapet.
Caution! The e ects of gravity bring with them the danger of uncontrolled falling or sinking. The
securing point is not designed to withstand the shock-like stress of an abrupt fall!
Contact the manufacturer without fail should uncertainties arise during installation or operation.
1
Before each use and after unusual occur-
rences, the carrying handle (5) that is
used for fastening the safety rope must be
inspected by an individual with expertise
in this area. The carrying handle (5) is not
permitted to exhibit any cracks, corrosion,
notches or other material faults.
The additional weights must be reliably se-
cured with the safety clamps (1 each at the
front and rear) provided for this purpose.
In cases of power mains failure, during
work interruptions or when cooling down,
you must swivel the hot-air blowers (10)
into park position and allow them to engage
10
there.
While doing so, take care to ensure that the
lock of the hot-air blowers (15) engages!
15
71