Work Display - Leister VARIMAT V2 Instructions D'utilisation

1. Work mode

1.2 Work display

• Pressing the e-Drive
Setpoint display changes to the Work display.
• When the welding nozzle (9) is heating up, this is indicated on
the display (5) with progress bar and arrow
the actual value of the welding temperature (flashing).
• If the mains voltage is outside (+/- 15%) the specified nominal
voltage (200 V, 230 V, 400 V), this is displayed flashing with the
symbol and the measured undervoltage/overvoltage.
If the air volume is less than 100 %, the percentage indication
changes with the
The welding result can be affected, depending on the undervoltage/
overvoltage.
• If no button is pressed after a definite time (welding nozzle (9)
NOT in welding position), the Standby menu is displayed (section
1.9, Standby).
• If the welding nozzle is not swivelled in, the menus Cool Down (section 1.8, Cooling down) or Profiles
(section 1.7, Selecting profiles) can be selected by turning the e-Drive
• If the welding nozzle (9) is swivelled in, the two menu items disappear
and can no longer be selected.
• If the welding nozzle (9) is cooling down, this is indicated with filled out progress bar and arrow
(down) as well as flashing actual value of the welding temperature on the display (5).
26
starts the heating and blower, and the
symbol.
(up) together with
.
on the display (5)