Setting The Drive Speed; Setting The Welding Temperature - Leister VARIMAT V2 Instructions D'utilisation

1. Work mode

1.3 Setting the drive speed

• The drive speed can be adapted with the Drive button
the e-Drive
can be carried out with the drive switched on or off.
• If the welding nozzle (9) is not in the welding position, the symbol
appear at the lower left edge of the displays (5).
• The drive can be switched on by pressing the e-Drive
appearing. The drive speed can be adjusted directly by turning the e-Drive
• Pressing the e-Drive
display or Cool down appears on the display.
• If no entry is made by the controls (4) within 3 seconds, the new drive speed will be accepted.
The Setpoint display or Cool down appears on the display (5).
• If the Drive button
measurement, blower and drive counter).
• You can change to the relevant menu by pressing the Heating

1.4 Setting the welding temperature

• The welding temperature can be changed with the Heating button
temperature can be set in 10°C increments from 100°C to 620°C by turning the e-
Drive . The setting is accepted after 3 seconds, as long as no button is pressed
within these 3 seconds.
• If this menu is called up from the Setpoint display, heating and blower can be started
by pressing the e-Drive
selected (section 1.8, Cooling down).
• If the Heating button
and the mains voltage will appear below the drive. This call-up is only possible from
the Work display (section 1.2).
• The air volume is automatically reduced at a set welding temperature of 500°C and higher.
However, the user can manually adjust the air volume using the Blower button
(see section 1.5).
If a star appears after the air volume display
temperature is no longer ensured.
• You can change to the relevant menu by pressing the Drive
in 0.1 m/min. increments from 0.7 m/min. to 12.0 m/min. This setting
again executes the Stop command, which switches off the drive. The Setpoint
is pressed for 3 seconds, the display will change to another menu (section 1.6, Length
. Once the heating is switched on, the cool down can be
is pressed within 3 seconds, the display (5) will change
. This can be set by turning
, the following symbol
.
or Blower
. The welding
, achievement of the welding
or Blower
will
Stop
button.
button.
27