Settings On The Hemtek St / K-St; Setting And Assembling Table Fastening - Leister HEMTEK ST Notice D'utilisation

5. Settings on the HEMTEK ST / K-ST

5.1 Setting and assembling table fastening

Use only stable tables or workbenches that can support the load without tipping over.
Two persons are required to transport the welder.
Set table fastening
2 x socket head screws per foot
Mount HEMTEK ST / K-ST on table fastening
Clamping feet can be adjusted to the differ-
ent tables using the two socket
head screws.
• Mount table fastening on table using
enclosed socket head bolts
(Check stability.)
• Position HEMTEK ST / K-ST on table fas-
tening. Make sure that the machine is
mounted parallelly to table fastening.
• Tighten the HEMTEK ST / K-ST using the 4
socket head bolts
• Check correct seating and stability of the
welder.
23