Quick Reference Guide Hemtek St / K-St; Warning Messages (Hemtek St / K-St) - Leister HEMTEK ST Notice D'utilisation

7. Quick Reference Guide HEMTEK ST / K-ST

Risk of clamping injuries!
A danger of clamping injuries exists with the tilting
mechanism when the hot-air blowers swivel in and out.
Risk of entanglement!
During operation there is a risk of entanglement
on the drive roller.
Risk of burning!
Do not touch heating element, nozzle and compo-
nents in the immediate vicinity of the nozzle when hot.
The device should always first be allowed to cool down.
Do not point the hot air flow at people or animals!
Switching on/Starting
1. Connect the mains voltage plug
2. Switch on the main switch (10)
3. Select/set the welding profile
4. Use the direct heating button (24) to switch on the
heating / wait until the operating temperature has been
reached (up to 5 min.)
5. Actuate the foot pedal or the pressure button (21), hot-
air blowers swivel in and the drive starts
Switching Off
1. Actuate the foot pedal or the pressure button (21), hot-
air blowers swivel out and the drive stops
2. Use the Direct heating button (24) to switch off the heating.
3. LED (23) flashing (cooling down process)
4. LED (23) no longer flashing: Switch off the main switch (10)
5. Pull out mains voltage plug

8. Warning messages (HEMTEK ST / K-ST)

Message type
Warning
Display
Both LEDs, the Status LED Drive (20)
and the Status LED Heating (23) are
flashing.
Temperature graph for 100% air volume
and 230 V nominal voltage
Error description
Mains frequency error
The air volume can no longer be adjusted.
29