Status Folder - Ingersoll Rand R30 Information De Produit

93014.15.06
Page 6 : Backlight Settings
Figure 53 : Backlight Settings
The following settings are displayed in this section:
Table 23 : Backlight Settings
Display Text Description
Backlight Adjusts the brightness of the display.
Brightness
Enable Backlight Enables the controller to shut-off the backlight if
Auto-Off there is no user activity for the delay time shown.
Backlight Auto-Off Determines how many seconds of inactivity it will
Delay Time take before the controller will shut-off the backlight.
The backlight will be switched ON whenever any of the controller's
keys are pressed.
The START, STOP, LOAD, UNLOAD, RESET, and ACKNOWLEDGE keys on
the controller remain functional while the backlight is switched OFF. It
is recommended to press the ENTER key or one of the navigation keys
in order to switch the backlight ON.
Pages 7-8: Ethernet Settings
Figure 54 : Ethernet Settings
The following settings are displayed in this section:
Table 24 : Ethernet Settings
Display Text
Enable Ethernet
Enable DHCP
IP Address Setting
80447162 Rev B
NOTICE
Description
Allow connection by users to utilize the network
enabled functionality of the controller.
Allow the controller to automatically receive an IP
address from the Local Area Network (LAN).
When DHCP is not enabled, this setpoint sets the
IP address of the controller.
Display Text Description
IP Address Actual This will match the IP address setting when DHCP
is not enabled. If DHCP is enabled this will display
the address assigned to the controller by the
DHCP server.
MAC Address This is the unique hardware MAC address for the
controller. This can not be changed.
Subnet Mask Setting Setpoint for the subnet mask.
Subnet Mask Actual Current reading/setting for the subnet mask.
Default Gateway Setpoint for the default gateway.
Setting
Default Gateway Current reading/setting for the default gateway.
Actual
Accept After editing the desired setpoint navigate to the
accept setting and press enter in order for the
values in the setting variables to be confi rmed by
the controller.
Cancel Discard any changes made to the Ethernet
settings.


Status folder

All information on these pages is read only.
Pages 1 -2: Analog Inputs
Figure 55 : Analog Inputs
The following inputs are displayed in this section:
• Package Discharge Pressure
• Sump Pressure
• Airend Discharge Temperature
• Injected Coolant Temperature
• After-cooler Discharge Temperature
• Separator Pressure Drop
• Coolant Filter Pressure Drop
• Inlet Vacuum
• After-cooler Discharge Pressure (integrated dryer compressors only)
• Remote Pressure (optional)
• Coolant Filter Inlet Pressure
• Coolant Filter Outlet Pressure
• Interstage Pressure (2-stage compressors only)
• Evaporator
• Condenser
NOTICE
EN
EN-29