Operating Instructions (Xe-90M Controller); User Interface; Led Status Icons; Command Keys - Ingersoll Rand R30 Information De Produit

93014.15.06
EN


User Interface

The standard user interface confi guration of the controller consists of the
membrane and the LCD display. The membrane consists of fi ve command
keys (START, STOP, LOAD, UNLOAD, and RESET), four navigation keys (UP,
RIGHT, LEFT and DOWN), and an Edit mode selection key (ENTER). These keys,
the color graphics display and the LED icons make up the user interface to
the compressor.


LED status icons

Three LED icons are used to indicate the current status of the control system
from a distance and are located on the upper left side of the user interface.
Icon Name
OK
Alert
Auto


Command keys

These keys command the controller to perform actions as specifi ed in the
following table. When any of these keys are pressed the action below will be
initiated and logged in the event log.
Icon Name
---
Load
Unload
Reset
EN-12

OPERATING INSTRUCTIONS (XE-90M CONTROLLER)

Figure 7 : Xe-90M
Table 4 : LED Status Icons
Function
Illuminates when no Warnings or Trips are sensed.
Can be in a Ready or Not Ready state.
Illuminates when an Warning (fl ashes) or Trip
(constant ON) is sensed. Can be in a Ready
(Warning) or Not Ready (Trip) state.
Illuminates when the compressor stops in auto
restart.
Table 5 : Command Keys
Function
None
Puts the compressor into the selected mode of
operation. Unit will load if the pressure conditions
are right.
Puts the compressor into an unloaded state. Unit
will run unloaded.
Clears Warnings and Trips once the condition is
corrected.
Icon Name Function
Start Starts the compressor.
Stops the compressor. This button should be
Stop pressed instead of the E-Stop for normal stopping
operation.
Toggles the display between the Navigation mode
Enter
and the Edit mode.
The LOAD and UNLOAD keys are not used on variable speed
compressors.


Navigation keys

There are four navigation keys (UP, RIGHT, DOWN and LEFT). While the ENTER
key is not considered a navigation key, it is used in conjunction with the
navigation keys to make or confi rm a selection.
Figure 8 : Navigation Keys
Pressing one of the navigation keys will lead the user down a navigation path.
Each time the key is pressed, another step in the path is taken. Once the end
of a navigation path is reached, pressing the key one more time will bring the
user back to the beginning of the path. Pressing the opposite key, will move
the user through the navigation path in the opposite direction. Once the
beginning is reached, pressing the opposite key will take the user to the end
of the path.


Display layout

Figure 9 : Display Layout
Table 6 : Display Layout
Key Name Description
A Folder Bar Uses tabs to graphically identify each folder.
B Title Bar Identifi es current folder and page (underlined).
C Page Content Content of the current page.
D Dashboard Displays system status.
NOTICE
80447162 Rev B