Device Use; Operating Instructions - I-Tech PHYSIO Notice D'utilisation

Splitting leads use: please use splitting leads if you want to double electrodes
number for each channel. Connect the splitting cable jacks to the self-adhesive
electrodes, with the cable disconnected from I-TECH PHYSIO; position the self-
adhesive electrodes on the skin (see photos of electrode positions in the
Positions manual); connect the splitting leads cables to the impulse
transmission cables that are connected to the relative jacks (Channel 1 and/or
Channel 2), then turn I-TECH PHYSIO on.
Make sure that I-TECH PHYSIO is switched off before disconnecting the
electrodes at the end of the treatment.

Device use

I-TECH PHYSIO has 14 preadjusted TENS programs, 27 preadjusted REHA
programs, 21 preadjusted NEMS programs, 15 preadjusted BEAUTY programs,
9 URO programs and 12 free memories adjustable by the user to create
programs according to his needs. The program MEM 13 is a battery test.

Operating instructions

It is recommended reading the entire user manual before using.
To start the therapy, turn I-TECH PHYSIO on using the
PREADJUSTED PROGRAMS
Read the follow instructions to use the preadjusted programs and start the
therapy:
1. Select the program group using the MODE/ESC button (NEMS, TENS,
BEAUTY, URO, REHA, MEM).
2. Select the program using PRG+ and PRG- buttons (refer to the follow
sections to get all technical specifications).
3. Increase current intensity for the channels using CH1 and CH2 (▲)
buttons. The value can be adjusted with stepping 1mA. Press CH1 and
CH2 (▼) buttons to decrease the intensity. I-TECH PHYSIO recognize
the electrodes connection: in case of faulty connection, when the
intensity reaches 10mA the value is resetted to zero.
4. The remaining time is showed on the display of I-TECH PHYSIO. An
acoustic signal advises the user when the treatment is completed.
5. Turn off the device keeping pressed the
seconds.
IACER Srl
button for at least two
89
button.
MNPG154-06