Patient Preparation - I-Tech PHYSIO Notice D'utilisation

• be sure that the electrodes well adhere to the skin. Repeated use of the
same electrodes can compromise the safety of the stimulation, in fact it
can cause skin redness that can last for many hours after stimulation;
pay attention to use connection cables with children/young people:
•
strangulation danger;
• do not mix connection cables up with earphones or other devices and do
not connect the cable to other equipment;
keep right distance between electrodes: the contact between electrodes
•
could cause wrong stimulations or irritations/burns;
stimulation intensity and electrodes position should be suggested by the
•
prescriber doctor.
The manufacturer considers himself responsible for the performances,
reliability, safety and security of the device only if:
any addition, modification and/or repair are carried out by authorized
•
personnel;
the environmental electrical installation to which I-TECH PHYSIO is
•
connected is compliant to the national laws;
• the instructions for use contained in this manual are strictly followed.
Should any foreign materials penetrate the device contact the retailer or
manufacturer immediately. If dropped down, check that the housing is not
cracked or damaged in any way; if so, contact the retailer or manufacturer.
Should you notice any changes in the device's performance during treatment,
interrupt the treatment immediately and consult the retailer or manufacturer.
If the stimulation is uncomfortable decrease intensity. If the problem
persists consult a doctor.
Some patients could suffer from skin irritation or oversensitivity due
to stimulation or gel. If the problem persists, suspend the stimulation
and consult a doctor.
Consult a doctor before using I-TECH PHYSIO with metallic
osteosynthesis devices.
IF YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT YOUR
DOCTOR.

Patient preparation

Before using I-TECH PHYSIO clean the skin of the area to be treated; with the
cable disconnected from I-TECH PHYSIO, connect the electrostimulation cable
jacks to the self-adhesive electrodes; position the self-adhesive electrodes on
the skin (see photos of electrode positions in the Positions manual); connect
the impulse transmission cables to the relative jacks (Channel 1 and/or Channel
2), then turn I-TECH PHYSIO on.
IACER Srl 88 MNPG154-06