Testing Your - Dogtra 2500T Serie Mode D'emploi

TESTING
NOTE 1 : The sound that the beeper will emit
will vary depending on your selection with the
(High/Low) toggle switch. The two-dog model:
Dogtra 2502 T&B has a fixed beeper sound
based on the color of the collar.
NOTE 2 : When using the Run/Point mode or
the Point-Only mode, the beeper volume level
reverts back to the volume level that was last
used.
NOTE 3 : In the Run/Point or Point-Only mode
the tone can be changed by holding down the
"Locate" button and then pressing the
"Mode" button when the High/Low toggle
switch is in the desired position.
The unit must be activated and in the
Run/Point or Point-Only mode first.
NOTE 4 : In the Run/Point or Point-Only mode
it is still possible to use electrical stimulation.
* To make sure that your Beeper Volume is in
working condition, please refer to page 68 for
further testing instructions.
76

TESTING YOUR

The
just like the
The difference between the one-dog and two-dog
collar is noticeable on the transmitter where a
toggle switch allows you to select either collar.
The toggle switch is color-coded with green
and orange to match the green and orange collar
straps. The orange collar emits a low tone double
beep and the green collar gives a high tone single
beep so you can distinguish between dogs when
they are out of sight.
The two-dog models have a toggle switch on
the face of the transmitter located above the
"Nick" button. The toggle switch allows for
selection of either collar.
Set the toggle switch on the orange position
to select the orange collar and the green position
to select the green collar.
ORANGE COLLAR: Double beep with low
GREEN COLLAR : Single beep with high
tone
TESTING
two-dog unit operates
single-dog unit.
tone
77