Fitting The Collar On The Dog; Familiarizing The Dog To The Beeper Sound - Dogtra 2500T Serie Mode D'emploi

FITTING THE COLLAR ON THE DOG

FITTING THE COLLAR ON THE DOG
The collar should be fitted so that the
Surgical Stainless Steel contact points press
firmly against the dog's skin.
A loose fit can allow the collar to move
around on the dog's neck. When this
happens, the contact points may rub the skin
and cause irritation. If the collar is too loose,
electrical contact will be inconsistent and
your corrections will be inconsistent also.
Dogtra uses Surgical Stainless Steel
contact points and Anti-microbial plastic to
protect the dog's skin.
78
FITTING THE COLLAR ON THE DOG
ATTENTION!
Avoid having the dog wear the collar
with the contact points in the same place for
more than 8 hours out of every 24-hour
period. Leaving the points on the same spot
for extended periods of time can cause skin
irritation. If the dog is to wear the e-collar
for long periods, occasionally reposition the
collar so that the contact points are moved
to a different spot on the dog's neck.
FAMILIARIZING THE DOG TO THE
BEEPER SOUND
Turn the beeper collar on and leave it
outside the dog's kennel area for about a half-
hour.
Repeat this several times, until you can see
that the dog disregards the beeper.
Next, adjust the beeper volume level to
level L1, the lowest level. Fit the beeper collar
on the dog. Select the desired beeper volume
level as the dog becomes accustomed to the
beeping sound.
79