Dogtra 2500T Serie Mode D'emploi page 39

TESTING
3. Turn the transmitter on by pressing the blue
button on the right side of the transmitter.
The LCD screen shows the amount of battery
life remaining and the LED blinks once every
4 seconds. (The battery needs charging, if the
color of the LED is red or the LCD battery icon
shows 1 bar.)
4. Watch the test light as you push the "Nick"
button on the transmitter. It should light for
just a moment.
5. Watch the test light as you push the "Constant"
button on the transmitter. As a safety
feature, the collar/receiver will automatically
shut off stimulation if the constant button is
depressed for 12 seconds or longer.
6. Turn the intensity dial on the transmitter
clockwise and then counterclockwise while
holding the "Constant" button down.
The test light should glow brighter with higher
levels of stimulation and dimmer with lower
levels. When you change the intensity dial, the
number on the LCD screen will change as well.
NOTE : It is normal for the test light not to
come on if the intensity level is set below level
ten.
74
7. To make sure that your beeper is working
properly, press the Locate button once with the
horn portion facing away from you (or place
your hand over the horn). The sound may be
extremely loud and may cause discomfort to
your ears. If you do hear an audible beeper
sound, your location button is in working order.
8. Press the Mode button once; you should hear
2 rapid beeps. This will put you into the
Run/Point Mode. Keep the receiver/collar
steady to mimic your dog at a standstill point.
Wait for a moment until you hear a double beep
in 2-second intervals. You may proceed to the
next step if the double beep occurs.
9. Press the Mode button a second time; you
should hear 1 rapid beep. This will put you into
the Point-Only Mode. Once again, keep your
receiver/collar steady and wait for a moment
until the collar emits a double beep every 2
seconds. If it is audible, move onto the next
step.
10. Press the Mode button a third time; you should
hear 3 rapid beeps. This mode will turn off
your beeper and remain silent.
TESTING
75