Button Function - Dogtra 2500T Serie Mode D'emploi

BUTTON FUNCTION

BUTTON FUNCTION
Lccate
Mode
The transmitter for the
has five buttons (two on the face of the
transmitter, two on the left side, and one on
the right side).
"Nick" Button
When the "Nick" button is pushed, the
receiver emits a single, rapid pulse of
electrical stimulation.
62
Beeper Sound
Toggle Switch
Nick
Constant
ON/OFF
Switch
"Constant" Button
When the "Constant" button is pushed, the
receiver emits a continuous stimulation as long
as the button is pushed, for up to 12 seconds. If
the button is not released after 12 seconds, the
stimulation will automatically turn off as a
safety feature. The collar will be ready to be
reactivated once the button has been released.
"Locate" Button
The "Locate" button is located on the left
side. It causes the collar's beeper horn to emit a
series of beeps when pushed and it gives you
the ability to keep track of your dog's location.
On one-dog models, the beeper can be adjusted
between high and low tones. NOTE: The
high/low tone is not an option on two dog units.
On two-dog models, the Green collar emits
the high tone and the Orange collar the low tone
automatically.
"Mode" Button
Your
modes. Locate, Run/Point, and Point-Only. The
"LOCATE" mode can be activated at any time,
even when another mode is set, by pressing the
top orange button labeled "LOCATE" on the
BUTTON FUNCTION
has three different
63