Charging The Batteries - Dogtra 2500T Serie Mode D'emploi

CHARGING THE BATTERIES

CHARGING THE BATTERIES
Polymer batteries.
1. Charge the unit before using the unit for the
first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries if the unit is to be
stored without use for a period of 3 months
or more.
Recharge the unit if:
The indicator light on the collar is emitting
a red color.
80
uses Lithium-
CHARGING THE BATTERIES
If the 3 bar indicator on the transmitter LCD
shows just 1 bar.
The indicator light on the transmitter or
receiver will not come on.
The indicator light on the transmitter or
receiver comes on momentarily, but will not
stay on when the "Constant" button is pushed.
Battery Charging Procedure
Note : The unit has a partial charge when it
leaves the Dogtra facility, upon receipt of
the collar, be sure to give it a full 2-hour
initial charge before the first use.
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on page
2. Plug the charger into a 220-volt wall outlet
or, if using the accessory field charger, plug
into a cigarette lighter only for Lithium-
Polymer battery. (Use a 120-volt U.S.A
charger for U.S.A.) When properly plugged
in, all indicator lights should glow red.
During the charging process, the unit will
shut off. Once the battery cable is unplugged
from the unit after a full charge, you will
need to turn the unit on again before use.
82
81