Charging The Batteries - Dogtra RB 1000 Serie Mode D'emploi

CHARGING THE BATTERIES

CHARGING THE BATTERIES
Polymer batteries.
1. Charge the unit before using the unit for the
first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries if the unit is to be
stored without use for a period of 3 months
or more.
64
uses Lithium-
CHARGING THE BATTERIES
Recharge the unit if :
The indicator light on the collar is emitting a
red color.
If the 3 bar indicator on the transmitter LCD
shows just 1 bar.
The indicator light on the transmitter or
receiver will not come on.
Battery Charging Procedure
Note : The unit has a partial charge when it
leaves the Dogtra facility, upon receipt of the
collar, be sure to give it a full 2-hour initial charge
before the first use.
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on page
2. Plug the charger into a 220-volt wall outlet
or, if using the accessory field charger, plug
into a cigarette lighter only for Lithium-
Polymer battery. When properly plugged in,
all indicator lights should glow red. During
the charging process, the unit will shut off.
Once the battery cable is unplugged from the
unit after a full charge, you will need to turn
the unit on again before use.
64.
65