Charging The Batteries - Dogtra 3500NCP Notice D'utilisation

CHARGING THE BATTERIES

Dogtra 3500NCP Super-X Series uses Lithium- Polymer batteries.
3. Fully charge the batteries if the unit is to be stored without use
for a period of 3 months or more.
66
Recharge the unit if :
• The indicator light on the collar is emitting a red color.
• If the 3 bar indicator on the transmitter LCD shows just 1 bar.
• The indicator light on the transmitter or receiver will not come
on.
• The indicator light on the transmitter or receiver comes on
momentarily, but will not stay on when the "Constant" button is
pushed.
Battery Charging Procedure
NOTE : The unit has a partial charge when it leaves the Dogtra
facility, upon receipt of the collar, be sure to give it a full 2-hour
1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 66.
2. Plug the charger into a 220-volt wall outlet or, if using the
Lithium-Polymer battery(Use a 110-volt U.S.A charger for
Europe). When properly plugged in, all indicator lights should
Once the battery cable is unplugged from the unit after a full
charge, you will need to turn the unit on again before use.
67