Finding The Right Level; Charging The Battery - Dogtra YS VIBE Manuel Du Propriétaire

Attention!
Leaving the receiver in the same location on the dog's
neck for an extended period of time can cause skin
irritation due to sensitivity. If the dog is to wear the
receiver for long periods, occasionally reposition the
receiver every few hours to a different location on the
dog's neck and remove the receiver after eight hours of
usage. Make sure you check for skin irritation each time
you use the unit.

FINDING THE RIGHT LEVEL

Remember that you will need to adjust the setting (upward
or downward) depending on your dog's temperament
and threshold. Always start at the lowest level and work
your way up. If you use the highest vibration level from the
beginning, the dog may become used to that level and the
system may not be effective.
30

CHARGING THE BATTERY

1. Plug the charger into the receiver, as shown above.
2. Plug the charger into a 220 volt wall outlet or, if using
the auto charger, plug into a cigarette lighter for lithium
polymer batteries. All indicator lights should glow red
when properly plugged in and the unit will automatically
shut off during the charging process.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging the unit, cover the battery charging
receptacle with the rubber plug on the receiver.
Note: Only use Dogtra-approved lithium polymer batteries
and chargers for your Dogtra unit. This will prevent any
damage that can be incurred from attempting to use a
different charger.
31