Fitting The Collar On The Dog - Dogtra 1800NC Serie Manuel D'instruction

TESTING
3. Watch the test light as you push the
"Nick"button on the transmitter. It should light
for just a moment.
4. Watch the test light as you push the "Constant"
button on the transmitter. It should light for as
long as the button is pressed. However, as a
safety feature,the collar/receiver will
automatically shut off stimulation if the constant
button is depressed for 12 seconds or longer.
5. Turn the Rheostat Intensity Dial on the
transmitter clockwise and then
counterclockwise.
The test light should glow brighter with higher
levels of stimulation and dimmer with lower
levels.
NOTE : The test light may not luminate if the
intensity level is set below level eight.
54
All manuals and user guides at all-guides.com

FITTING THE COLLAR ON THE DOG

FITTING THE COLLAR ON THE DOG
The collar should be fitted so that the
Surgical Stainless Steel contact points press
firmly against the dog's skin. You should be
able to fit a finger in between the contact point
and your dog's skin.
A loose fit can allow the collar to move
around on the dog's neck. When this happens,
the contact points may rub the skin and cause
irritation. If the collar is too loose, electrical
contact will be inconsistent and your
corrections will be inconsistent also.
55