Fitting The Collar On The Dog - Dogtra 1210NCP Serie Manuel Du Propriétaire

TESTING
3. Turn the transmitter on by pressing the blue
button on the right side of the transmitter until the
LCD screen illuminates. The LCD screen shows
the amount of battery life remaining and the LED
blinks once every 4 seconds.
4. Watch the test light as you push the "Nick" button
on the transmitter. It should light for just a
moment.
5. Watch the test light as you push the "Constant"
button on the transmitter. It should light for as
long as the button is pressed. However, as a safety
feature, the collar/receiver will automatically shut
off stimulation if the constant button is depressed
for 12 seconds or longer.
6. Turn the Rheostat Intensity Dial on the transmitter
clockwise and then counterclockwise. The test
light should glow brighter with higher levels of
stimulation and dimmer with lower levels. When
you change the intensity dial, the number on the
LCD screen will change as well.
7. Pressing the "Pager" button on the front of the
transmitter causes the collar to vibrate for up to 12
seconds. The collar will reactivate when you push
the button again.
NOTE : The test light may not come on if the
intensity level is set below level ten.
56

FITTING THE COLLAR ON THE DOG

FITTING THE COLLAR ON THE DOG
The collar should be fitted so that the
Surgical Stainless Steel contact points press
firmly against the dog's skin. You should be able
to fit a finger in between the contact point and
your dog's skin.
A loose fit can allow the collar to move
around on the dog's neck. When this happens,
the contact points may rub the skin and cause
irritation. If the collar is too loose, electrical
contact will be inconsistent and your corrections
will be inconsistent also.
57