Levels; Contact Points; Fitting The Collar - Dogtra YS 500 Manuel D'instructions

CONTACT POINTS

NOTICE :
1. When first using the "Anti-bark collar", it is
recommended that you start with the lowest
level.
2. If the dog continues to bark, gradually increase
the intensity level.
CONTACT POINTS
The contact points must make good contact with
the skin for the unit to function properly.
IMPORTANT : When screwing in the contact
points, tighten by hand only.
46

FITTING THE COLLAR

1. Tighten the collar around the dog's neck so
that the points are in contact with the dog's
skin.
2. If the collar is too loose, the dog will not
receive correction when it barks.
3. Check the dog's neck daily for possible
irritation caused by the contact points
rubbing the skin.
4. Do not leave the collar on for more than
eight hours a day.
IMPORTANT : Remove any other collars from
your dog when it is wearing the Anti-bark
collar. A metal collar or metal buckle that rubs
against the Anti-bark collar sensor may
inadvertently activate the unit.
FITTING THE COLLAR
47