Battery Charger - Dogtra 3500NCP Notice D'utilisation

Receiver Battery Charging Receptacle & Rubber Plug
On the inside of the receiver/collar, next to the collar strap, is a
battery-charging receptacle with a rubber plug.
Internal Antenna
All Dogtra e-collars have non-exposed antennas that are located
inside the receiver/collar.
60
Battery Charging
Receptacle & Rubber Plug

BATTERY CHARGER

Charging Cable
Two-dog unit only
The battery charger and charging cables allow you to charge both
the transmitter and receiver at the same time.
The battery charger is designed for a 220-volt wall outlet
(U.S.A. 110-volt AC chargers and 10-volt field charger for
Lithium-Polymer batteries for your automobile are also
available.).
To use the battery charger for the two-dog unit, combine both sets
of battery charging (splitter) cables as shown.
This enables you to charge the transmitter and both receivers at
the same time.
NOTE : Only use Dogtra-approved Lithium-Polymer Battery
Chargers for your Dogtra e-collar.
This will prevent any damage that can be incurred from
attempting to use a different charger.
220 volt
Charger
Wall Outlet
61