Battery Charger; Testing Your - Dogtra RB 1000 Serie Mode D'emploi

BATTERY CHARGER

BATTERY CHARGER
Charging Cable
Two-dog unit only
The battery charger and charging cables
allow you to charge both the transmitter and
receiver at the same time. The battery charger is
designed for a 220-volt wall outlet. 12-volt field
charger for Lithium-Polymer batteries for your
automobile are also available.)
To use the battery charger for the two-dog
unit, combine both sets of battery charging
(splitter) cables as shown. This enables you to
charge the transmitter and both receivers at the
same time.
NOTE : Only use Dogtra-approved
Lithium-Polymer Battery Chargers for your
Dogtra beeper collar. This will prevent any
damage that can be incurred from attempting
to use a different chargerThe battery charger.
60
120 volt
Charger
Wall Outlet

TESTING YOUR

COLLAR
1. To activate the
should place the red dot on the back of the
transmitter to the red dot on the collar
receiver. And hold the two red dots together
for a moment until the green color LED
indicator light comes on.
The collar/receiver emits the Power-on
melody and turns on.
2. Turn the transmitter on by pressing the blue
button on the right side of the transmitter.
The LCD screen shows the amount of
battery life remaining and the LED blinks
once every 4 seconds. (The battery needs
charging, if the color of the LED is red or
the LCD battery icon shows 1 bar.)
3. You should make sure whether the toggle
switch is located where you want between
"GR" and "OR". If you select the orange
collar, set the toggle switch on the "OR" and
to choose the green collar, set it on the
"GR".
TESTING
, you
61