Battery Charger; Testing Your Dogtra Rb 1000 Series - Dogtra RB1000 Serie Notice D'utilisation

CHARGEUR DE BATTERIE
The battery charger and charging cables allow you to
charge both the transmitter and receiver at the same
time. The battery charger is designed for a 220-volt
wall outlet (10-volt field charger for Lithium- Polymer
batteries for your automobile are also available.).
To use the battery charger for the two-dog unit,
combine both sets of battery charging (splitter) cables
as shown. This enables you to charge the transmitter
and both receivers at the same time.
NOTE : Only use Dogtra-approved Lithium-Polymer
Battery Chargers for your Dogtra beeper collar. This
will prevent any damage that can be incurred from
attempting to use a dif ferent chargerThe battery
charger.
62
TESTING YOUR Dogtra RB 1000
SERIES COLLAR
1. To activate the Dogtra RB 1000 Series, you should
place the red dot on the back of the transmitter to the
red dot on the receiver/collar. And hold the two red
dots together for a moment until the green color LED
indicator light comes on. The receiver/collar emits the
Power-on melody and turns on.
2. Turn the transmitter on by pressing the blue button
on the right side of the transmitter. The LCD screen
shows the amount of battery life remaining and the
LED blinks once every 4 seconds (The battery needs
charging, if the color of the LED is red or the LCD
battery icon shows 1 bar.).
3. You should make sure whether the toggle switch is
located where you want between "GR" and "OR". If
you select the orange collar, set the toggle switch on
the "OR" and to choose the green collar , set it on the
"GR".
4. The selected sound continues quickly as long as the
Locate button is pressed, for up to 12 seconds.
5. To choose a sound among four types, use the Sound
button.
63