Dogtra RB1000 Serie Notice D'utilisation page 36

Battery Charging Procedure
Note : The unit has a partial charge when it leaves the
Dogtra facility, upon receipt of the collar, be sure to give
it a full 2-hour initial char ge before the first use.
1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 63.
2. Plug the charger into a 220-volt wall outlet or, if
using the accessory field charger, plug into a cigarette
lighter only for Lithium-Polymer battery. When
properly plugged in, all indicator lights should glow
red. During the charging process, the unit will shut of
f. Once the battery cable is unplugged from the unit
after a full charge, you will need to turn the unit on
again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the char ging
process. The red light will change into a steady green
light when the battery is fully char ged (When you
disconnect the charger after finishing the charge, you
will need to restart the units).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver.
NOTE : Only use Dogtra-approved batteries, chargers,
and accessories for your Dogtra beeper collars. When
a charger is not in use, disconnect it from the power
source.
68
Charger Info
Manufacturer: HON-KWANG
Manufacturing country: CHINA
Model name: HK-AW-100A150-EU
INPUT: 100~240V~50/60Hz 0.4A
OUTPUT: 10V 1.5A
Attention!
During battery charging, the unit must be close to
the wall outlet and the wall outlet must be easily
accessible for security reasons.
69