Button Function - Dogtra RB 1000 Serie Mode D'emploi

BUTTON FUNCTION

BUTTON FUNCTION
Lccate
Sound
The transmitter for the
has five buttons (two on the face of the
transmitter, two on the left side, and one on
the right side).
"Run/Point" Button
The Run/Point button is located on the
front of the transmitter.
If you push down the Run/Point button,
the unit causes double beep every 7 seconds
while the dog is running. While the dog is on
point or stationary it double beeps every 2
seconds.
52
Run/Point
Point
ON/OFF
Switch
"Point" Button
The Point button is below the Run/Point
button on the front of the transmitter.
The unit will not beep while the dog is
moving in case the Point button is pressed (you
can use the Locate mode for locating your dog);
however when the dog points or becomes
stationary, the unit will emit a double beep
every 2 seconds.
(Orange Collar : double beep, Green
Collar : single beep)
"Locate" Button
The "Locate" button is located on the left
side. It causes the collar's beeper horn to emit a
series of beeps when the button is pushed and it
gives you the ability to keep track of your dog's
location. The current selected sound lasts as
long as the Locate button is pushed down, for
up to 12 seconds.
"Sound" Button
The Sound button is located below the
Locate button on the left side of the transmitter.
It has four different sounds.
BUTTON FUNCTION
53