Testing Your Dogtra 3500Ncp Super-X Series Collar - Dogtra 3500NCP Notice D'utilisation

TESTING YOUR
Dogtra 3500NCP Super-X Series
COLLAR
1. To activate your Dogtra 3500NCP Super-X Series place the red
dot on the back of the transmitter to the red dot on the receiver/
collar. Hold the two red dots together for a moment until the
green colored LED indicator light comes on.
2. Place the test light included in the package contents on the
contact points as shown in the diagram.
62
3. Turn the transmitter on by pressing the blue button on the right
side of the transmitter until the LCD screen illuminates. The
LCD screen shows the amount of battery life remaining and the
LED blinks once every 4 seconds.
4. Watch the test light as you push the "Nick" button on the
transmitter. It should light for just a moment.
5. Watch the test light as you push the "Constant" button on
the transmitter. It should light for as long as the button is
pressed. However, as a safety feature, the receiver/collar will
depressed for 12 seconds or longer.
6. Turn the Rheostat Intensity Dial on the transmitter clockwise
and then counterclockwise. The test light should glow brighter
with higher levels of stimulation and dimmer with lower levels.
When you change the intensity dial, the number on the LCD
screen will change as well.
7. Pressing the "Pager" button on the front of the transmitter
causes the collar to vibrate for up to 12 seconds. The collar will
reactivate when you push the button again.
NOTE : The test light may not come on if the intensity level is set
below level ten.
63