Testing Your Anti-Bark Collar - Dogtra YS300 Notice D'utilisation

TESTING YOUR ANTI-BARK COLLAR

1. Turn the YS300 on by turning the ON-OFF & Intensity
Dial and select "TEST" Level so that the arrow on the dial is
aligned with the "test" line.
does not bark over 10 seconds, it will turn to the Sleep mode to
40
2. Test by scratching the rough surface of the test tool on the
collar (as shown in the diagram) using a coin. The collar will emit
a vibration three times. Then repeat the same process if you want
to try it again.
* When the Anti-Bark Collar emits a vibration, a
stimulation is not emitted at the same time.
* When you set the dial on the TEST Level,
it may be sensitive enough that the Anti-Bark Collar
can be activated easily by a small sound.
41