Testing Your; Prior To Installation - Dogtra eF-3000 GOLD Manuel D'instruction

TESTING

TESTING YOUR

PRIOR TO INSTALLATION

1. To ensure that your
system is working properly, connect the
transmitter adaptor into the adaptor of the
transmitter and then plug the adaptor into a
household outlet. Switch the stimulation knob
to Pager+Stimulation, or Stimulation Only. The
ON/OFF indicator light should turn on.
2. Unwind the length of ground wire that was
provided and strip about 1/2 inch off each end.
68
Insert one end of the ground wire into the first
wire connector jack and the other end into the
third, leaving the center jack free. If the wires are
connected properly, the wire indicator light will
be on.
3. Next, activate the collar/receiver by turning the
intensity level dial on the receiver to the desired
level. The LED light will blink once every two
seconds showing that it is on. If not activated for
10 seconds or more, the system will go into sleep
mode.
4. Hold the receiver in your hand with the contact
points facing up. Place the test lamp over the
contact points and approach the test loop.
5. Watch for the test light to come on and/or the
unit will emit the warning vibration if the unit is
in this mode at the wall mount transmitter. Be
careful not to touch the contact points as the unit
will emit stimulation when activated.
TESTING
69