Dogtra eF-3000 GOLD Manuel D'instruction page 29

TRANSMITTER
Wire Connectors For Splicing
The easy-to-use push-release wire connectors let
you instantly connect or disconnect the boundary
wire leads. Wires should be stripped approximately
a half-inch before being inserted into the red
connectors on the bottom of the wall mount
transmitter.The
comes with a ground wire to protect the unit in the
event of lightning/power surge. Strip about a half-
inch on each end of the ground wire and insert one
end into the black connector on the bottom of the
wall transmitter. The other end should be buried
into the ground or wrapped around a water pipe and
secured with electrical tape.
Option : A lightning/surge protector can be
purchased if there are no grounding options near the
wall transmitter.
56
system
Adaptor Receptacle
Plug the 220-volt adaptor into a 220-volt wall
outlet and insert the adaptor plug into the adaptor
receptacle of the transmitter.
TRANSMITTER
57