Dogtra 2500T Serie Mode D'emploi page 34

BUTTON FUNCTION
left side of the transmitter. To set the beeper
unit to Run/Point mode, press the orange
"MODE" button. This button is located on the
left side of the transmitter, under the
"LOCATE" button.
When you press the "MODE" button the
first time, the collar will beep twice. The
beeper unit will always start in Run/Point
mode. It is now in Run/Point mode. The beeper
will sound every 7 seconds while the dog is
running, and every 2 seconds when the dog is
gone on point or become stationary.
The second time you push the "MODE"
button, it will beep once, remain silent while
the dog is running and beep every 2 seconds
when the dog is on point or stationary.
To turn the beeper unit off, press the
MODE button a third time. The unit will emit
three rapid beeps, and the beeper will turn off.
The Locate mode can still be used!
When the toggle switch is set on Low tone,
the beeper will emit a double beep when it is in
Run/Point mode or Point-only mode. If the
toggle switch is set on the High tone, a single
beep will sound when using Run/Point or
Point-Only mode.
64
Initial Beeper
Mode
Sound
Run/
Press 1 st
2 Beeps Point
Time
Mode
Point-
Press 2
nd
1 Beep Only
Time
Mode
Press 3 rd
3 Beeps Beeper
Time
* NOTE : The locate button can still be
utilized in whichever mode you are in.
BUTTON FUNCTION
Action
-Dog running: Double
beep every 7
seconds.
-Dog on-point: Double
beep every 2
seconds.
-Dog running :
Remains Silent.
-Dog on-point :
Double beep every
2 Seconds.
Unit Turned off
65