Wall Control Procedures - Emerson GEODE CF370BS00 Mode D'emploi

7.1
Your Emerson Ceiling Fan/Light Control consists of
Wall Mounted Transmitter and a Receiver located
inside the Ceiling Cover. The Control is designed to
remotely operate your Ceiling Fan Speed and Light
Intensity.
7.2
Your Wall Control has Code Switches which must be
set in one of 32 possible code combinations
(Figure 32). The Five Levers (numbered 1, 2, 3, 4,
and 5) on the Switches are factory-set in the ON (up)
position. Change the Switch settings as follows:
NOTE: Do not duplicate the code of an existing
control of an installed ceiling fan within 100 feet.
7.3
Slide the Five Switch Levers in the Wall Control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the Levers firmly up
or down.
7.4
The Sixth Switch marked ON and I is for Dimming
Control of Lights: Set Switch to ON to allow for
Dimming of the Lights. Set Switch to I for No Dimming
of the Lights.
7.5
Preset Memory Feature: Your Emerson Ceiling Fan/
Light control is equipped with a preset memory feature.
When the electricity supply to the Fan is switched OFF,
the Control will remember the Light Intensity and Fan
Speed. When the Switch is turned back ON, the Light
and Fan will resume operation as they were prior to the
Switch being turned OFF.

7. Wall Control Procedures

Code Switches in the Transmitter may be set in
32 different positions. If your Fan and Light turn ON and
OFF without using your Control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems.
To remedy this situations, simply change the Code
Switches in your Transmitter per the instructions of
Section 7.2.
Figure 32
20
WALL CONTROL
CODE SWITCHES
ON
1 2 3 4 5
I
CODE
SWITCHES
WALL
CONTROL
ETL Model No.: CF370