How To Wire Your Ceiling Fan - Emerson GEODE CF370BS00 Mode D'emploi

5. How to Wire Your Ceiling Fan

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
5.2
Locate the Electronic Receiver and insert its Antenna
Wire into the opening of the Hanger Bracket above
the Hanger Ball. Continue to insert the body of the
Receiver (flat side facing up) into the opening, orient as
shown. Be careful not to pinch any Wires between the
Receiver body and the Bracket or Ball (Figure 18).
WARNING
!
To avoid possible fire or shock, do not pinch the
antenna wire between the hanger bracket and the
receiver.
5.1
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to Wire
the Ceiling Fan.
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product.
Substitution of parts or accessories not designated
for use with this product by Emerson could result in
personal injury or property damage.
RECEIVER ANTENNA WIRE
Figure 18
12
WARNING
RECEIVER
ETL Model No.: CF370