How To Wire Your Ceiling Fan - Emerson LOFT CF765BQ01 Mode D'emploi

5. How to Wire Your Ceiling Fan

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
All wiring must be in accordance with National
nd Local codes and the ceiling fan must be
properly grounded as a precaution against
possible electrical shock.
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the Fan.
NOTE: Make all wiring connections using
wire connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
5.1
Connect the Hanger Ball Green Grounding Wire and the
Hanger Bracket Green Grounding Wire to the Supply
Grounding Conductor (this may be a bare wire or wire
with green colored insulation) (Figure 15).
Securely connect Wires with Wire Connector (supplied)
(Figure 15).
5.2
Securely connect the Fan Motor White Wire to the
Supply White (neutral) Wire using a Wire Connector,
supplied (Figure 16).
HANGER BRACKET
GREEN GROUND
Figure 15
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Figure 16
12
HANGER BRACKET ASSEMBLY
SUPPLY
GREEN WIRE
WIRE
CONNECTOR
FAN MOTOR
GREEN WIRE
HANGER BALL/DOWNROD ASSEMBLY
WARNING
HANGER BRACKET
ASSEMBLY
SUPPLY WHITE
(NEUTRAL) WIRE
WIRE
CONNECTOR
FAN MOTOR WHITE
(NEUTRAL) WIRE
HANGER BALL/DOWNROD
ASSEMBLY
U.L. Model No.: CF765-1