Emerson LOFT CF765BQ01 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.7
While pulling up on the 6" Downrod, reinstall and
tighten the Two Set Screws (previously removed) in
the Motor Coupler to secure the Downrod into place
(Figure 7).
NOTE: The set screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the set screws in the motor coupler are
properly installed and securely tightened. Failure to
verify that the set screws are properly installed could
result in the fan falling.
3.8
Make sure the Grommet is properly installed in the
Motor Coupler Cover.
Slide the Motor Coupler Cover on the Downrod until it
rests on the Motor Cover (Figure 8).
Be sure the Motor Coupler Cover is oriented correctly
(Figure 8).
3.9
Place the Ceiling Cover over the Downrod and let it rest
on the Motor Coupler Cover.
Be sure the Ceiling Cover is oriented correctly
(Figure 9).
(Continued)
Figure 7
CEILING COVER
GROMMET
MOTOR COUPLER
MOTOR COUPLING
COVER
COVER
MOTOR COVER
Figure 8
CEILING COVER
MOTOR COUPLER
MOTOR COUPLING
COVER
COVER
MOTOR COVER
Figure 9
8
DOWNROD
RETIGHTEN TWO
PHILLIPS HEAD
SET SCREWS
MOTOR
COUPLER
6" DOWNROD
DOWNROD
DOWNROD
U.L. Model No.: CF765-1