Wall Control Procedures - Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi

7.1
Your Emerson Ceiling Fan/Light Control consists of Wall
Mounted Transmitter and a Receiver which is mounted
under the Fan Ceiling Cover. The Remote Control is
designed to separately control your Ceiling Fan Speed
and Light Intensity.
7.2
Your Wall Control has Code Switches which must be set
in one of 32 possible Code Combinations (Figure 25).
The Five Levers (numbered 1, 2, 3, 4, and 5) on the
Switches are factory-set in the ON (up) position. Change
the Switch settings as follows:
NOTE: Do not duplicate the code of an existing
control of an installed ceiling fan within 100 feet.
7.3
Slide the Five Switch Levers in the Wall Control to your
choice of ON (up) or Down Positions. Use a ball-point pen
or small screwdriver and slide the Levers firmly up or
down.
7.4
The Sixth Switch marked ON and I is for Dimming Control
of Lights: Set Switch to ON to allow for Dimming of the
Lights. Set Switch to I for No Dimming of the Lights such
as for fluorescent bulbs and non-dimming CFLs.
7.5
Preset Memory Feature: Your Emerson Receiver is
equipped with a preset Memory Feature. If the AC Supply
to the Receiver is powered through a Wall Switch, when
the Switch is turned OFF, the Control will remember the
Light Intensity and Fan Speed. When the Switch is turned
back ON the Light and Fan will resume operation as they
were prior to the Switch being turned OFF.

7. Wall Control Procedures

Code Switches in the Transmitter and Receiver may be
set in 32 different positions. If your Fan and Light go on
and OFF without using your Control, you may be getting
interference from other Remote units such as garage door
openers, car alarms or security systems. To remedy this
situations, simply change the Combination Code in your
Transmitter and Receiver.
Figure 25
17
WALL CONTROL
CODE SWITCHES
ON
1 2 3 4 5
I
CODE
SWITCHES
WALL
CONTROL